![]() recreating the G code file in MeshCAM Art, and loading into Mach3), the problem persists. 25" into the work piece when it is supposed to be in a retracted position of 0.100" above the stock!Īfter multiple attempts of starting over from scratch (I.E. NOT GOOD, since depending on the program file loaded, indicates that the tool will start out by being plunged as deep as. However, (and this is the core of the problem) the Z axis positive limit DRO now reads a NEGATIVE number. Mach reads through the entire file, and updates the program limits for each axis. Upon loading the G Code file created by MeshCAM Art, and then navigating to the Toolpath screen in Mach and clicking Regenerate Toolpath button (something I have made it a habit of always doing, to check that the program limits in Mach 3 match what was created in MeshCAM). ![]() I have encountered a problem, that I have been unable to dechipher. ![]() I am using MeshCAM Art to create 3D toolpaths for wood carvings on my Router table.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |